Paper Cup machine operating procedures to standardize the staff to the paper cup machine operating procedures, to prevent safety, quality accidents, to ensure the smooth operation of production, especially the establishment of the operating procedures: 1. Before taking over, the next employee should get the required materials, such as paper, cup bottom, Carton, sealant, silicone oil, etc. . 2. Open the control panel power button, check the machine power is normal, set the temperature can reach the predetermined value. 3. Add a little lubricating oil to the moving parts of the machine to lubricate, wipe the parts that the products need to touch to avoid pollution, and check the connecting screw of the running parts of the machine, whether the top wire is loose. Four. Check the smoothness of the paper, whether off-film, spots, both sides of the confusion, wrinkle and other phenomena. 5. When necessary to the paper to spray an appropriate amount of water, strictly control the paper water time and humidity. 6. Check the air pressure valve and adjust it to the required pressure. Seven. Put the paper on the bottom of the cup, pay attention to the front and back.
Start-up production work: 1. After the completion of the preparation work, in the motor will start a shout“On” in the absence of any response, can start the motor. This action is to prevent the mechanic in the opposite side or behind the machine repair, the operator can not see and cause unnecessary safety accidents. 2. Carefully observe the machine operation, take a cup to check the paper cup bonding effect, preheat, main heat, Knurling there is no yellowing, damage to the paper cup situation. 3. Check the bonding effect of adhesive, there is no indirect bad situation, the bottom of the cup and adhesive bonding firm degree for tearing and pulling phenomenon is appropriate, there is indirect not pulling is suspected to leak cup, after water test shall prevail. Four. In normal operation, such as the discovery or sense of the machine is abnormal place to raise the cup body, such as the last cup after the kerosene can be stopped to check. 5. Midway unexpected downtime for a longer period of time to re-open the machine, the market will be fourth. Take out five, check whether the knurled parts are bonded. 6. The Paper Cup machine operator pays attention to the molding condition of the cup rim, the cup body and the cup bottom at any time in the normal production. Seven. Employees in the operation of concentration, found abnormal voice or cup bottom molding is not good, to stop immediately to check, to prevent causing greater losses. 8. Operators in the production process to do a serious and responsible for their own production of the cup every hour with boiling water test once, each time 8. 9. The operator should check the quantity of small package before sealing the carton, cut and paste the product certificate or product design on the upper right corner of the left side of the carton, and fill in the work number and production date in the carton, finally, seal the box and stack it neatly in the designated position.
Work after shutdown: 1. Turn off the console power, cut off the main power, shut off the air valve and silicone oil valve. 2. Clean up the residual paper inside and outside the machine, pick up the water gun and other auxiliary tools. 3. Tidy up the working environment, clean up and keep the equipment clean.
Post time: Jun-14-2023